Lubbock Water Heater Odor Repair

Are you having a problem with stinky odors originating from the water originating from your water heater? It occurs sometimes for a couple different reasons. Here is what Water Heater Repair Lubbock TX advises to do to make sure your water smells considerably better and to eliminate any undesirable tastes soon.

Reasons for Lubbock Water Heater Smells?

Bacteria getting into the water system is the most common reason ones water inside the house will have smells. If you home utilizes well water or cities that use wells for the water supply, will increase the chance of this taking place.

With a water heater temperature level setting of 140 degrees or above will help in reducing the development of microorganisms inside the water storage tank.

Ways to Eliminate Smelly Water Odors

The following instructions demonstrate the way to use chlorine bleach to thoroughly clean a water heater.

The electric or gas leading to the water heater tank needs to first be turned off.

Next, the cold water supply off that goes to the tank needs to be shut off.

Open the hot water faucet of the kitchen area sink to allow air to get in the tank.

With a a yard hose hooked up to the storage tank drain valve, drain the water inside the water heater.

Then shut the drain valve as soon as it is empty.

The next step is adding the bleach.
If the hose for the cold water going inside the storage tank is a flexible hose, unscrew it from the tank. Otherwise, one will have to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be removed.

Use a funnel to put bleach into the tank.
Use 5 ounces of bleach for each gallon of the tank ability.
So if you have a 50 gallon water heater, you will require 250 ounces of bleach, or about 2 gallons.

Hook the water line or pressure relief valve back up again

Fill the tank back up with water once again.

Close up the hot water faucet of the kitchen area faucet as quickly as all the air runs out the line.

Operate all the hot water appliances until the smell of bleach is noticeable. We want to kill the microorganisms that are located in the water lines likewise, not only inside the water heater.

Keep the water in the tank and water lines undisturbed for two to 3 hours.

Drain the storage tank again and refill it. This time allow it to remain for at least 30 minutes and once again drain it.

Fill the tank back up. Turn on all of the hot water fixtures and let them run until the scent of bleach is gone.

For gas water heaters, relight the water heater pilot light. For electric water heaters, turn the power on again.

Additionally, by replacing the anode rods, or perhaps the type utilized can work as the following video illustrates:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Lubbock Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog